sourCEntral - mobile manpages

pdf

r.buffer

NAME

r.buffer

DESCRIPTION

r.buffer creates a new raster map layer showing buffer (a.k.a. "distance" or "proximity") zones around all cells that contain non-NULL category values in an existing raster map layer. The distances of buffer zones from cells with non-zero category values are user-chosen. Suppose, for example, that you want to place buffer zones around roads. This program could create the raster map layer shown below on the right based on road information contained in the raster map layer shown on the left.
000000000000000000000000 222233333333333333444444
111000000000000000000000 111222222222223333333333
000111111111100000000000 222111111111122223333333
000000001000011100000000 332222221222211122222222
000000001000000011111111 333333321233222211111111
000000001000000000000000 433333321233333222222222
000000001000000000000000 444443321233333333333333
000000001000000000000000 444443321233443333333333
000000001000000000000000 444443321233444444444444
Category 0: No roads
Category 1: Road location
Category 2: Buffer Zone 1 around roads
Category 3: Buffer Zone 2 around roads
Category 4: Buffer Zone 3 around roads

NOTES

The user has the option of identifying up to 250 continuous zones. The zones are identified by specifying the upper limit of each desired zone (r.buffer assumes that 0 is the starting point). ("Continuous" is used in the sense that each category zone’s lower value is the previous zone’s upper value. The first buffer zone always has distance 0 as its lower bound.) Distances can be entered in one of five units: meters, kilometers, feet, miles, and nautmiles (nautical miles).

Distances from cells containing the user-specified category values are calculated using the "fromcell" method. This method goes to each cell that contains a category value from which distances are to be calculated, and draws the requested distance rings around them. This method works very fast when there are few cells containing the category values of interest, but works slowly when there are numerous cells containing the category values of interest spread throughout the area.

r.buffer measures distances from center of cell to center of cell using Euclidean distance measure for planimetric locations (like UTM) and using ellipsoidal geodesic distance measure for latitude/longitude locations.

r.buffer calculates distance zones from all cells having non-NULL category values in the input map. If the user wishes to calculate distances from only selected input map layer category values, the user should run (for example) r.reclass prior to r.buffer, to reclass all categories from which distance zones are not desired to be calculated into category NULL.

EXAMPLE

In the following example, the buffer zones would be (in the default units of meters): 0-100, 101-200, 201-300, 301-400 and 401-500.
r.buffer input=
roads output=roads.buf distances=100,200,300,400,500
Result:
r.cats input=
roads.buf
1 distances calculated from these locations
2 0-100 meters
3 100-200 meters
4 200-300 meters
5 300-400 meters
6 400-500 meters

SEE ALSO

g.region
r.cost
r.mapcalc
r.reclass
v.buffer

AUTHORS

Michael Shapiro, U.S. Army Construction Engineering Research Laboratory
James Westervelt, U.S. Army Construction Engineering Research Laboratory

Last changed: $Date: 2006/09/13 12:28:04 $

Full index

pdf