atlantic-setup − Setup program for ethernet cards based on AT/LANTIC DP83905 chips.
atlantic-setup [options]
atlantic-setup is a setup and diagnostic program for ISA NE2000 Ethernet adapters. It has specific support for configuring the National Semiconductor AT/LANTIC DP83905 used in on ISA Ethernet adapters such as the NE2000plus. It also works several work-alike chips from other vendors.
These programs follow the usual GNU command line syntax, with long options starting with two dashes (‘-’). A summary of options is included below.
−h, −−help
Show summary of options.
−V, −−version
Show version of program.
−v, −−verbose
Verbose mode.
−q, −−quiet
Be very unverbose.
−a, −−all
Print all registers.
−N, −−NE2000
Set card to NE2000 mode.
−W, −−wd8013
Set card to WD8013 mode.
−p, −−base-address <port>
Specify port to use. Valid values are: 0x240, 0x280, 0x300, 0x320, 0x340, 0x360 (default: 0x300).
−P, −−new_ioport <port>
Set card to use new port. Valid values are: 0x240, 0x280, 0x300, 0x320, 0x340, 0x360 (default: 0x300).
−F, −−interface <interface>
Interface number. Valid Options are: 10baseT, 10base2, 10base5, AUI.
−Q, −i, −−irq <irq>
Specify new interrupt. Valid values are: 3-5,9-12,15.
−w, −−write-EEPROM <values>
Write to the EEPROMS with the specified values.
This manual page was written by Alain Schroeder <alain AT debian DOT org>, for the Debian GNU/Linux system (but may be used by others).