sourCEntral - mobile manpages

pdf

TARG(4) BSD Kernel Interfaces Manual TARG(4)

NAME

targ — SCSI target emulator driver

SYNOPSIS

To compile this driver into the kernel, place the following line in your kernel configuration file:

device targ

DESCRIPTION

The targ driver provides an interface for usermode programs to emulate SCSI target devices. A sample program that emulates a disk drive (similar to da(4)) can be found in /usr/share/examples/scsi_target.

The targ driver supplies control devices, /dev/targ0, /dev/targ1, etc. If a device is already in use, open(2) will fail and errno will be set to EBUSY. After opening the device, the file descriptor must be bound to a specific bus/target/LUN and enabled to process CCBs using the TARGIOCENABLE ioctl. The process then uses write(2) to send CCBs to the SIM and poll(2) or kqueue(2) to see if responses are ready. Pointers to completed CCBs are returned via read(2). Any data transfers requested by the user CCBs are done via zero-copy IO.

IOCTLS

The following ioctl(2) calls are defined in the header file <cam/scsi/scsi_targetio.h>.

TARGIOCENABLE

(struct ioc_enable_lun) Enable target mode on the LUN specified by the following structure:

struct ioc_enable_lun {

path_id_t

path_id;

target_id_t

target_id;

lun_id_t

lun_id;

int

grp6_len;

int

grp7_len;

};

The selected path (bus), target, and LUN must not already be in use or EADDRINUSE is returned. If grp6_len or grp7_len are non-zero, reception of vendor-specific commands is enabled.

TARGIOCDISABLE

Disable target mode and abort all pending CCBs. The CCBs may optionally be read as they complete. TARGIOCENABLE can then be called to activate a different LUN. Multiple disable calls have no effect. The close(2) system call automatically disables target mode if enabled.

TARGIOCDEBUG

(int) Enables CAM_PERIPH debugging if the argument is non-zero, otherwise disables it.

FILES
<cam/scsi/scsi_targetio.h>

describes the usermode interface.

/sys/cam/scsi/scsi_target.c

is the driver source file.

/dev/targ*

are the control devices.

SEE ALSO

/usr/share/examples/scsi_target, ahc(4), isp(4), scsi(4)

FreeBSD Target Information

,

http://www.root.org/~nate/freebsd/ .

AUTHORS

The targ driver first appeared in FreeBSD 3.0 and was written by Justin T. Gibbs. It was rewritten for FreeBSD 5.0 by Nate Lawson 〈 nate AT root DOT org〉 .

BUGS

Currently, only the ahc(4) and isp(4) drivers fully support target mode.

The ahc(4) driver does not support tagged queuing in target mode.

BSD November 15, 2002 BSD

pdf