sourCEntral - mobile manpages

pdf

DE(4) BSD Kernel Interfaces Manual DE(4)

NAME

de — DEC DC21x4x Ethernet device driver

SYNOPSIS

To compile this driver into the kernel, place the following line in your kernel configuration file:

device de

Alternatively, to load the driver as a module at boot time, place the following line in loader.conf(5):

if_de_load="YES"

DESCRIPTION

The de driver provides support for the Ethernet adapters based on the Digital Equipment DC21x4x based self-contained Ethernet and Fast Ethernet chips.

The de driver supports the following media types:

autoselect

Enable autoselection of the media type and options

10baseT/UTP

Set 10Mbps operation on the 10baseT port

10base2/BNC

Set 10Mbps operation on the BNC port

10base5/AUI

Set 10Mbps operation on the AUI port

100baseTX

Set 100Mbps (Fast Ethernet) operation

100baseFX

Set 100Mbps operation

100baseT4

Set 100Mbps operation (4-pair cat-3 cable)

The de driver supports the following media options:

full-duplex

Set full duplex operation

Note that the media types available depend on the particular card in use. Some cards are explicitly programmed to a particular media type by a setup utility and are not changeable.

Use the ifconfig(8) command and in particular the −m flag to list the supported media types for your particular card.

The old ‘‘ifconfig linkN’’ method of configuration is not supported.

HARDWARE

Adapters supported by the de driver include:

Adaptec ANA-6944/TX

Cogent EM100FX and EM440TX

Corega FastEther PCI-TX

D-Link DFE-500TX

DEC DE435, DEC DE450, and DEC DE500

ELECOM LD-PCI2T, LD-PCITS

I-O DATA LA2/T-PCI

SMC Etherpower 8432, 9332 and 9334

ZNYX ZX3xx

DIAGNOSTICS

de%d: waking device from sleep/snooze mode  The 21041 and 21140A chips support suspending the operation of the card.

de%d: error: desired IRQ of %d does not match device’s actual IRQ of %d  The device probe detected that the board is configured for a different interrupt than the one specified in the kernel configuration file.

de%d: not configured; limit of %d reached or exceeded  There is a limit of 32 de devices allowed in a single machine.

de%d: not configured; 21040 pass 2.0 required (%d.%d found) 
de%d: not configured; 21140 pass 1.1 required (%d.%d found) 
Certain revisions of the chipset are not supported by this driver.

SEE ALSO

altq(4), arp(4), netintro(4), ng_ether(4), ifconfig(8)

AUTHORS

The de device driver was written by Matt Thomas. This manual page was written by David E. O’Brien.

BSD July 16, 2005 BSD

pdf